Publicité
Les langues disponibles
Les langues disponibles
Installation
1. Calibrating installation position outside the bumper, the height is 700 mm from the land,
15-20 degrees outward. Radar installed inside the bumper; fixing by 2 options:
A: by screws more strong:
Remove rear bumper, find the suitable position,drill the hole and fixed radar stand by screws
Put the radar on the stand, faixed by screws; Radar must be horizontal, the angle between the
transmitter and car body shall be 15-20 degrees to the left and right; angle between the transmitter
and land shall be 2-5degree upward, distance to the land not less than 70cm
Attention: cable of left&right radar shall be horizontal, not vertically; 2cable on the same level
B: by adhesive tape
Clean the inside position of the bumper with an alcohol pad, Put on the radar transmitting backside
with strong adhesive tape.(recommend 3M tape)
2. Put on the bumper.
3. Install the ECU and complete the wiring.
4. Paste the left and right warning lights on the A pillar.
5. Plug the power plug into the cigarette lighter socket and test it on electricity.
6. Warning light warning.
1
Confirm the installation point
3
Clean the sensor installation area at the bumper
5
Replace the bumper
Cable connection
Red cable ACC
Black cable GND ground
Blue cable right turing light (marked with right)
Blue cable left turing light (marked with left)
Make sure the installation
point at the flat area, and
this area should be as
perpendicular to the ground
as possible.
32
2
Remove the rear plastic bumper
4
Stick the sensor on inner bumper
6
Install the ECU and wiring
Install the ECU and complete the wiring as
page 8.
Publicité
