Publicité
Les langues disponibles
Les langues disponibles
Specifications:
System configuration: High accuracy Radar (Germany Technology)
Detection Accuracy: 0.1Meter
Max detection distance: 20M
Speed detection: 1KM/H – 120KM/H
Detection area: 0-6Meter
Way of warning: Flash light and alarm
Power consumption: DC12V 0.1A
Working voltage: DC12V
Working temperature: -25°C – 75°C
Storage temperature: -25°C – 80°C
Frequency of Radar: 24GHZ
Buzzer: 80 – 100dB
IP rate: IP44
Ten functions of products
1. Monitored without engingee start, operation immediately with power on.
2. Lane change warning function: monitoring target which close to rear, providing early warning signals
for the lane change.
3. Blind area monitoring function: monitoring adjacent lanes near the blind area.
4. Vehicle overtaking early warning: car overtaking on both sides, warning lights will turn on.
5. Rear end warning: warning for short distance at the rear, reduce emergency brake and avoid rear
end collision.
6. High speed vehicle priority monitoring: the faster the rear car comes, the farther the monitoring
distance is.
7. Key monitoring of large vehicles: emphasis on monitoring trucks, container trucks and buses.
8. Increasing the distance in the tunnel: super distance monitoring in high risk places such as tunnels.
9. 2 way warning of sound and light in dangerous situation: prepare to turn,pull the steering light lever,
if there is a car near the rear, system will make a rapid warning alarm, and the warning light flashes;
10. Open door anti-collision function: in parking condition, if there are vehicles or pedestrians closing
the vehicle, the warning light will turn on, remind drivers to pay attention.
Cautions for installation and operation
1. Pls read instruction manual carefully before installation; the removal and installation shall be carried
out accordance with the relevant requirements of the instruction manual;if found any parts damaged,
please replace it in time;
2. Turn off the car and loosen the positive and negative poles of the car battery; when disassembling or
connecting the system,do not pull the wires; to avoid wires broken or the protective sheath falls off;
3. When connection with system, make sure the connection tightly and fit;
4. Pls fixed the extra cables on original cables with nylon tie, but shall not be pulled too tightly. All
power and signal wire connections shall be protected by electrical tape, make it waterproof and
short-circuit proof.
5. Tools required for installation: spanner, screwdriver, 5mm drill and electric hand drill, glass glue.
31
Publicité
