TEFAL Chefclub ClipsoMinut' Duo Guide De L'utilisateur page 15

DESCRIPTION OF DIAGRAM
A. Operating valve
B. Steam release vent
C. Valve positioning mark
D. Pressure indicator
(see the "Safety" paragraph)
E. Safety valve
G. Lid handle
H. Lid
COMPULSORY CHECKS BEFORE EACH USE
Checking the operating valve
Check that the operating valve's drainage hole is not blocked (see the
"Removing and installing the operating valve" paragraph).
Checking the safety valve
Check that the safety valve's locking indicator is movable (push down on the
locking indicator several times with your finger).
24
(see the exploded-view diagram)
I. Seal
J. Steam basket
K. Stand
N. Pot handle
P. Maximum fill marks
(max 1 and max 2)
Q. Pot
USE
Cooking in Cooking in
Pressure Cooker mode Stewpot mode*
OPENING
Move the lid handle from a horizontal position to a vertical position
The lid should now turn.
Raise the lid.
If you have di culty opening the pressure cooker: run the seal under water
and put it back in the lid without drying it -
under the notches in the lid - Fig 13.
CLOSING
Make sure the lid handle is in the upright position.
Place the lid on the pot as shown in
the pot's handles.
Fold the lid handle from the vertical position to the horizontal position
It is normal the lid turns on the pot when the pressure cooker is closed, but
not in operation. This e ect disappears when it is pressurised.
If you cannot close the lid:
Check that the seal and the lid have been positioned correctly.
If you have di culty closing the pressure cooker: run the seal under water
and put it back in the lid without wiping it - Fig 17 and make sure to place it
under the notches in the lid - Fig 13.
USING FOR THE FIRST TIME
Thoroughly clean the pressure cooker and its components
before using them for the first time.
Wash and lightly oil, with cooking oil, the entire inner coated
surface.
Clip the stand (K) to the basket (J), then place the assembly
at the bottom of the pot.
Fill the pot (Q) with water to the 2/3 mark (MAX 2)
Close your pressure cooker.
Align the pictogram on the operating valve (A) with the
valve position mark (C) - Fig 9.
Place your pressure cooker on a suitable heat source, then set
it to its maximum power.
Steam release
- Fig
Fig 17 and make sure to place it
- Fig 1, by aligning the plastic part with
- Fig
- Fig 5.
EN
3.
2.
25