Recognising And Removing Interferences; Jetstamp Graphic 970 Does Not Work; Reasons For Rechargeable Batteries Not Being Charged - Reiner jetStamp graphic 970 Mode D'emploi

jetStamp graphic 970

4. Recognising and Removing Interferences

4.1. jetStamp graphic 970 does not work

Troubleshooting
Remove the USB cable from the jetStamp graphic 970.
f
Open battery compartment
f
Remove the rechargeable batteries.
f
Wait for approx. 3 seconds.
f
Replace the rechargeable batteries.
f
Connect the micro-USB socket of the device
f
Turn the setting wheel
f
Start the PCset graphic.
f
Check charge status display
f

4.2. Reasons for Rechargeable Batteries Not Being Charged

- No rechargeable batteries inserted or rechargeable batteries inserted incorrectly.
- Contacts in the battery compartment defective.
- Temperature of rechargeable batteries above 40 degrees Celsius.
- Rechargeable batteries too old.
- Rechargeable batteries defective.
- Rechargeable batteries completely discharged (deep discharge).
Capacity and service life
The rechargeable batteries reach their full capacity after several charge/discharge cycles.
With increasing age, the rechargeable batteries' operating time reduces.
Rechargeable batteries are subject to wear. A longer service life than six months cannot be
warranted.
78
Fig. A + C
2
.
7
to position 1.
i
(see "Operating Interface", page 58).
9
to the computer via the USB cable.