Acoustic Signals - Reiner jetStamp graphic 970 Mode D'emploi

jetStamp graphic 970

4.4. Acoustic Signals

Signal
1 sound impulse
1 sound impulse
every 10 seconds
2 sound impulses
every 30 seconds
3 sound impulse
4 sound impulse
5 sound impulses
per minute
80
Cause
- When the trigger button
is pushed while the set
wheel is in the position
F (see "Online Help",
page 57)
- No or defective print
cartridge
- Wrong print cartridge
- Ink level writing error
- Print cartridge not
inserted correctly
- Rechargeable battery
empty
- No rechargeable
battery/defective
rechargeable battery
- Print carriage move-
ment blocked
- Print cartridge almost
empty
- Print cartridge empty
- jetStamp graphic 970
not in the base station
- Battery nearly flat/
capacity low
Removal Notes
- Insert print - The detailed cause and
cartridge
- Insert print cart-
ridge correctly
- Charge recharge-
able battery
- Insert/replace
rechargeable
battery
- Check print
- Replace print
cartridge
- Put the jetStamp - The display appears after 30
graphic 970 in
the base station
- Visual signal as well
- Charge/replace
rechargeable
battery
removal can be
determined in the
status display of the
PCSet graphic software
seconds of non-use in stan-
dard ink, after 10 seconds in
MP2 ink and after 6 seconds
in MP3 ink
d