Maintenance; Replace Print Cartridge; Clean Print Cartridge Contacts - Reiner jetStamp graphic 970 Mode D'emploi

jetStamp graphic 970

3. Maintenance

3.1. Replace Print Cartridge

The ink level of the print cartridge can be determined in the status display of
the PCSet graphic software
Replace print cartridge
Depending on ink type used, different Protective Nozzle Seals are required
(see "Replace Protective Nozzle Seal", page 76).
Put the jetStamp graphic 970 in the base station
f
Turn the setting wheel
f
Keep the trigger button
f
Print carriage
Slightly push the lock of print cartridge
f
can be opened.
Open print cartridge flap
f
Remove print cartridge
f
Take new print cartridge
f
15
nozzles .
Put the jetStamp graphic 970 on a fixed flat surface.
f
Inserting printing cartridge
f
Closing the print cartridge flap
f
Push the trigger button
f
Print carriage

3.2. Clean Print Cartridge Contacts

Clean print cartridge contacts
In rare case, contamination of the print cartridge contacts
results.
Put the jetStamp graphic 970 in the base station
f
Turn the setting wheel
f
Keep the trigger button
f
Print carriage
Gently push the lock of print cartridge
f
be opened.
Open print cartridge flap
f
74
d
.
Fig. A +
7
to position 1.
1
pushed and take the device from the base station
3
moves to the middle position.
11
.
12
from the device.
12
from the packaging and remove protective film from the
12
.
11
.
1
.
3
moves to the home position.
Fig.
7
to position 1.
1
pushed and take the device from the base station
3
moves to the middle position.
11
.
B + D
4
.
13
to the right, until the print cartridge flap
A + B + D
14
4
.
13
to the right, until the print cartridge flap
4
may cause defective print
4
.
11
.
11
can