Manual Nozzle Cleaning; Clean Protective Nozzle Seal; Replace Protective Nozzle Seal - Reiner jetStamp graphic 970 Mode D'emploi

jetStamp graphic 970
Trigger automatic cleaning mechanism
A small amount of ink is ejected for cleaning of the nozzles
Take the device from the base station and put it on a level surface.
f
Turn the setting wheel
f
Push the trigger button
f

3.3.2. Manual Nozzle Cleaning

Manual nozzle cleaning
When the automatic nozzle cleaning does not lead to the desired success,
we recommend the following measure:
To loosen the dried ink, gently wipe a soft cloth possibly moistened slightly with
f
Ethanol (spirit) against the nozzles
Dab off dissolved ink and wipe the nozzles
f

3.4. Clean Protective Nozzle Seal

Clean Protective Nozzle Seal
The Protective Nozzle Seal
Dab the Protective Nozzle Seal
f
Clean the Protective Nozzle Seal
contamination or damage.

3.5. Replace Protective Nozzle Seal

Find a clip on our homepage at www.reiner.de or youtube.
Replace Protective Nozzle Seal
Depending on ink type used, different Protective Nozzle Seals are required.
Push down the Protective Nozzle Seal
f
Take it out at the Protective Nozzle Seal tip
f
Insert a new Protective Nozzle Seal into the holder.
f
Slightly push down the Protective Nozzle Seal until it latches in the holder.
f
76
7
to position C.
1
.
Fig. D + E
15
for approx. three seconds.
15
Fig. A + D
5
is located in the base station
5
clean with a soft cloth.
5
at regular intervals. Replace at stronger
Fig. A +
5
slightly at the front edge.
16
Fig. A + D
15
dry.
4
.
D
.
.