Reely 23 98 30 Notice D'emploi page 39

Step 5:
Connect the receiver power supply to the corresponding socket (C).
Step 6:
Put the on/off switch (B) for the receiver power supply in the „ON" position.
Step 7:
Disconnect the plug connection (E) and (D) in the plus line. Observe that the two plug connections do not touch and
that they do not touch any other metal parts of the vehicle either.
Step 8:
Connect a fully charged 6-cell LiPo battery (rated voltage 22.2 V) to the plug contact (F). Always ensure correct
polarity (red cable = plus/+, black cable = minus/-).
Step 9:
Now connect the plug (E) to the socket (D). A resistor integrated into the shrink hose of socket (D) prevents light arc
when connecting the drive battery.
Step 10:
Hold the vehicle, but do not reach into the drive unit. There is a risk of serious injury! Never hold the vehicle by its
wheels! First switch on the speed controller by putting the on/off switch (A) of the speed controller in the „ON"
position.
Step 11:
Before operating the vehicle, check whether the stationary model reacts as expected to the commands of the remote
control.
Set the trimming for throttle/brake at the transmitter so that the engine no longer turns when the lever (neutral
position of the throttle/bas lever at the transmitter) is released (transmitter throttle/braking lever).
Set the trim for steering so that the front wheels are about straight. The exact setting for straight driving can be
performed during a drive.
39