Product Presentation; General Description - ADEUNIS ARF8230CA Guide Utilisateur

LoRaWAN 863-870 PULSE - Guide utilisateur / User guide version V3.0.0
1.

PRODUCT PRESENTATION

IMPORTANT NOTE: the LoRaWAN 863-870 PULSE can only be started or restarted using a magnet.
Description
• LoRaWAN 863-870 PULSE is a ready to use radio transmitter that can be used to transform any
type of meter into a wireless meter (smart meter).
• This product meets the needs of users who require to remotely monitor the consumption of differ-
ent fluids (water, gas, electricity, heat ...) or any other phenomenon with an impulse interface (rain
gauge, odometer ...).
• The use of the LoRaWAN protocol allows the user to integrate the LoRaWAN 863-870 PULSE into
any network that is already deployed.
• Two 3 wires-meters or one 5 wires-meters may be controlled by a single LoRaWAN 863-870 PULSE
transmitter thus permitting a significant reduction in implementation and deployment costs.
• The product emits the data from the meters periodically with or without history. It allows also the
detection of tamper, and leakage, and the flow calculation with transmission possibilities on exceed-
ing high or low thresholds.
• The configuration of the transmitter is accessible by the user via a micro-USB port or remotely via
the LoRaWAN network, allowing in particular a choice of modes of transmission, periodicity or trig-
gering thresholds.
• The LoRaWAN 863-870 PULSE is powered by a non-replaceable internal battery.
IMPORTANT NOTE: The LoRaWAN 863-870 PULSE is delivered by default with OTAA configuration, al-
lowing the user to declare his/her product to a LoRaWAN operator For an ABP procedure, please con-
tact our Sales Department with the necessary information.
IMPORTANT NOTE: The LoRaWAN 863-870 PULSE can transmit measurements from the meters but
does not power them.
Package composition
The product is supplied in a cardboard package containing the following elements:
• Upper case, electronic board, case plate.
• Compression gland with nut, 3 compression seals, 2 CBLZ 2.2 x 19mm screws, 2 Fischer SX4 plugs.

1.1. General description

Casing base
Antenna
2 holes for
passing col-
lars through
4 fastening
holes
Rail-DIN un-
locking lever
Casing base detail
FR
EN
Cables outlet
packing gland
Page 61 of 103