Closing The Casing; Starting Up The Product Using A Magnet - ADEUNIS ARF8230CA Guide Utilisateur

LoRaWAN 863-870 PULSE - Guide utilisateur / User guide version V3.0.0

5.5. Closing the casing

Once previous stages have been carried out, you can close the casing of the
LoRaWAN 863-870 PULSE
Procedure:
1. Make sure that the seal is properly positioned on the base
2. Clip the electronic board onto the casing's base. Make sure that the fastening clip is properly
locked into the board's fitting.
3. Insert the upper part of the casing. Inside this part there are guide rails for the board. Make sure
that the board is properly positioned within these guides.
4. Once the board is in position, lower the upper cover and lock it onto the casing's base. Strong
pressure will enable both parts to be clipped together and will enable protection level IP67 to be
ensured.
1
3/4
Locking clips
for the upper
casing
5. Finish the assembly by locking the packing gland's nut in position

5.6. Starting up the product using a magnet

Once the product has been configured and its as-
sembly has been finalized, the product is ready to be
started up.
The start-up is carried out using a magnet which you
place on the upper part of the product (cf. the dia-
gram below). The magnet must be held in position
for at least 6 seconds so as to confirm the start-up of
the product. When the magnet is well detected, the
green LED lights up for 1 second.
Once the LoRaWAN 863-870 PULSE unit validates
its start-up, it immediately transmits status frames
followed by a data frame (according the defined pe-
riodicity).
Seal
Fitting
Fastening clip
Packing gland nut
2
5
Position of the
magnet for start-
ing up the prod-
uct
FR
EN
Page 95 of 103