Preparation; Dismantling The Case; Installation Of The Compression Seal; Assembly Procedure - ADEUNIS ARF8230CA Guide Utilisateur

LoRaWAN 863-870 PULSE - Guide utilisateur / User guide version V3.0.0
5.

PREPARATION

5.1. Dismantling the case

The product is supplied disassembled such that the lower electronic part can be accessed. This part
is where the meter or meters are connected to the screw terminals and where the micro USB port for
configuration of the device.
Once connection of the meters has been finalized and configuration carried out, the case may be
closed.

5.2. Installation of the compression seal

Before connecting your meter cables to the product's screw terminals, you must insert the compression
gland nut and the appropriate seal for your configuration.
3 types of seals are supplied with the PULSE: for a 5 mm diameter cable, for a 3 mm diameter cable,
for 2 x 2.2 mm cables.
Seal for 1 x 5 mm cable

Assembly procedure:

1 - Your meter 2 - Pass the
and its pulse cable through
interface. the compres-
sion gland nut.
Seal for 1 x 3 mm Seal for 2 x 2.2 mm
cable cables
90
3 - Pass the 4 - Pass the ca-
cable through ble through the
105
the compression PULSE'S case
gland seal plate.
27
5 - Verify that 6 - Connect
the O-ring seal the ends of
is correctly po- the meter
sitioned on the cable to the
case plate and screw termi-
not twisted. nals.
Page
FR
EN
91 of 103