Product Presentation; General Description - ADEUNIS PULSE IP68 V4 Guide Utilisateur

LoRaWAN 863-870 PULSE IP68 - Guide utilisateur / User guide V4.0.0
1.

PRODUCT PRESENTATION

NOTE: the LoRaWAN 863-870 PULSE IP68 can only be started or restarted using a magnet.
Description
• LoRaWAN 863-870 PULSE IP68 is a ready to use radio transmitter that can be used to transform
any type of meter into a wireless meter (smart meter).
• This product meets the needs of users who require to remotely monitor the consumption of differ-
ent fluids (water, gas, electricity, heat ...) or any other phenomenon with an impulse interface (rain
gauge, odometer ...).
• The use of the LoRaWAN protocol allows the user to integrate the LoRaWAN 863-870 PULSE IP68
into any network that is already deployed.
• Two 3 wires-meters or one 5 wires-meters may be controlled by a single PULSE transmitter thus
permitting a significant reduction in implementation and deployment costs.
• The product emits the data from the meters periodically with or without history. It allows also the
detection of tamper, and leakage, and the flow calculation with transmission possibilities on exceed-
ing high or low thresholds.
• The configuration of the transmitter is accessible by the user via a micro-USB port or remotely via
the LoRaWAN network, allowing changes on modes of transmission, periodicity or thresholds.
• The LoRaWAN 863-870 PULSE IP68 is powered by a replaceable internal battery.
• The PULSE IP68 is fully compatible with the KARE+ service.
IMPORTANT NOTE: The PULSE LoRaWAN is delivered by default with OTAA configuration, allowing the
user to declare his/her product to a LoRaWAN operator.
IMPORTANT NOTE: The LoRaWAN 863-870 PULSE IP68 can transmit measurements from the meters
but does not power them.
Package composition
The product is supplied in a cardboard package containing the following elements:
• Upper case, electronic board, case plate and 2 torx screws for the casing base.
• Compression gland with nut and 2 compression seals.

1.1. General description

Base casing
2 holes for
passing collars
through
4 fastening holes
Casing base detail
Cables outlet
packing gland
Page 39 of 58
FR
EN