ADEUNIS PULSE IP68 V4 Guide Utilisateur page 53

LoRaWAN 863-870 PULSE IP68 - Guide utilisateur / User guide V4.0.0
Eg:
Register Value encoding
S320 Hexadecimal
S322 Hexadecimal
S325 Decimal
S328 Decimal
S329 Decimal
S330 Decimal
S331 Decimal
In this example, all the periods during which the flow rate on the channel A is less than 10 pulses /
hour are considered as periods of zero flow. If the total daily number of zero flow periods is less than 3
then it is considered that there is a leak on the channel A.
2.5. Timestamp of the data
The sensor can integrate the timestamp of the last data in
the frame if the option is activated. Timestamp is given
in EPOCH 2013 (please, refer to the TRM of the product to
know the content of each frame).
To configure the timestamp, open the IoT Configurator and
go to the Applicative Configuration, in "Timestamp configu-
ration" check the box for "Timestamp activated".
Then you can go to the Advanced mode to set the UTC time
using the corresponding button.
In option, not recommended by Adeunis, it is possible to
determine a local timestamp sent by the product. To do so,
determine in the Timestamp Configuration the Timezone
where the product is installed, and choose if you want that
the product manage automatically the daylight saving time.
Value Result
0x39 Channel A:
• Activated
• Meter other than gas
• Tamper input activated
Channel B :
• Activated
• Gas meter
• Tamper input disabled
0x57 Anti-bounce :
• Channel A = 500ms
• Channel B = 100ms
60 Flow calculation period (channels A and B) = 60min
10 Leak threshold (channel A) = 10 pulses par hour
0 Leak threshold (channel B) = 0 pulse par hour
Daily periods number under the leak threshold (channel
3
A) = 3
5 Daily periods number under the leak threshold (channel
B) = 5
FR
EN
Page 53 of 58