Operation Of The Leds - ADEUNIS PULSE IP68 V4 Guide Utilisateur

LoRaWAN 863-870 PULSE IP68 - Guide utilisateur / User guide V4.0.0

2.6. Operation of the LEDs

Mode
Product in Park mode
Magnet detection process (1 to 6
seconds)
FR
Product start (after detection of
the magnet)
Joining process (Lora product)
EN
Network Quality test running
Network Quality test result
Switching to the Command mode Continuously lit
Product faulty (return to factory) Fixed ON
LEDs scenario for a sensor configured in Class A OTAA:
JOIN process :
LED blink suc-
cessively every
seconds
LED red state
OFF
OFF
OFF
During the JOIN phase: flashing:
50ms on / 1 s off
If the JOIN phase is complete
(JOIN accept):
flashing: 50ms on / 50ms Off
(6x)
10 to 20 seconds ON
Bad coverage : 10 seconds ON
Medium coverage : 10 seconds
ON
Good coverage : OFF
JOIN ACCEPT : Network test:
LED blink suc-
cessively every
50 ms
LED green state
OFF
ON from detection of the mag-
net up to a maximum of 1
second
Rapid flashing 6 cycles, 100 ms
ON / 100 ms OFF
During the JOIN phase: flash-
ing: 50ms on / 1 s off (just
after the red LED)
If JOIN phase is complete (JOIN
accept):
flashing: 50ms on / 50ms off
(just before the red LED)
10 to 20 seconds ON
Bad coverage : OFF
Medium coverage : 10 seconds
ON
Good coverage : 10 seconds ON
Continuously lit
Network test result:
LEDs during During 10 seconds
10 to 30 sec- Green= Good,
onds Orange = Medium,
Red = Bad
Page 54 of 58