Transmission Of The Keep Alive Frame; Operation Of The Led - ADEUNIS TEMP V3 LoRaWAN 863 Guide Utilisateur

TEMP V3 LoRaWAN 863-870 - Guide utilisateur / User guide version V3.0.0

2.2.5 Transmission of the Keep Alive frame

In the event mode, it is possible that the product would never send data frames. So to be sure that it is working properly a Keep Alive frame is
transmitted regularly (following diagram).
Parameters associated to this operating mode:
• Activation of the probes (register 324).
FR
• Transmission period of the keep alive frame, from 20 seconds to 7 days
(register 300).
Example:
Register Encoding
EN
S300 Decimal

2.3. Operation of the LED

Mode
Product in Park mode
Magnet detection process
Product start (after detection of the magnet) OFF
Joining process (LoRaWAN products)
Detection of the correct wiring of the
probes at startup
Switching to the Command mode
Battery level low
Product faulty (return to factory)
Value Result
The keep alive frame is sent every:
8640 8640x10 seconds =1440min so
24h (so once per day)
Red LED state
OFF
OFF
During the JOIN phase: flashing: 50ms on / 1
s off
If the JOIN phase is complete (JOIN accept):
flashing: 50ms on / 50ms Off (6x)
10 seconds ON if a default is detected
Continuously lit
Flashing (0.5s ON every 60s)
Fixed ON
Stand-by mode
No
Period reached
?
Yes
Measure of the tem-
perature on activated
probes
Sending 0x30
Green LED state
OFF
ON from detection of the magnet during 5
seconds
Rapid flashing 6 cycles, 100 ms ON / 100
ms OFF
During the JOIN phase: flashing: 50ms on /
1 s off (just after the red LED)
If JOIN phase is complete (JOIN accept):
flashing: 50ms on / 50ms off (just before the
red LED)
10 seconds ON if no default is detected
Continuously lit
48 of 51