Wiring; Disconnect A Probe; Wiring A Probe - ADEUNIS TEMP V3 LoRaWAN 863 Guide Utilisateur

TEMP V3 LoRaWAN 863-870 - Guide utilisateur / User guide version V3.0.0

5. WIRING

5.1. Disconnect a probe

To disconnect a probe, please follow these instructions:
1
FR
EN
2
open the product by pulling on the cable gland
WARNING : do not pull on the wires
As a reminder the probe 1 is on the rounded side of the housing, the probe 2 is on the flat side of the housing.

5.2. Wiring a probe

In order to wire a probe, please follow these instructions:
1
2
open the product by pulling on the
cable gland
WARNING : do not pull on the wires
1
2
3
1
2
3
using a suitable screwdriver,
unscrew the terminal block to
detach the wires
unscrew the cable gland to
loosen the cable
once the cable has been re-
moved, insert the gland plug
provided in the package to
maintain the watertightness of
the product
remove the stuffing plug
insert the probe cable supplied with
the product and connect the wires to
the terminal blocks*:
• for the probe 1 terminal blocks 3
and 4
• for the probe 2 terminal blocks 1
and 2
*The wiring of the probes at the right place is
important to match the associated registers and
for the interpretation of the results (cf. Technical
Reference Manual, Registers).
50 of 51