Philips HR2375 Mode D'emploi page 4

ENGLISH
6
5 Attach the front panel to the main unit.
Note:
y Make sure the front panel is completely fastened before using the appliance.
y The front panel is heavy. Take extra caution when assembling it.
6 Fasten the front panel control knobs.
Note: If the front panel or the shaping disc is not properly assembled, a safety switch will
prevent the appliance from working.
7 Close the mixing chamber lid.
Note: If the mixing chamber lid is not properly installed, the safety switch will prevent the
appliance from working.
Using the Pasta maker
Preparing the ingredients
Note: Use the supplied flour/water cup to measure flour and liquid.
Flour
1 cup of flour (~250 g)
2 cups of flour (~500 g)
1 Use a kitchen scale to measure the flour. (Fig. 15)
Note: Refer to the table above or the recipe book for the correct ratios.
2 Remove the mixing chamber lid. (Fig. 3)
3 Pour the flour into the chamber. (Fig. 16)
Note: Do not put less than 200g or more than 500g of flour in the chamber.
4 Measure the required amount of liquid according to the flour you have used. (Fig. 17)
Note: Refer to the table above or the recipe book for the correct ratios.
Starting the pasta making program
1 Put the plug in the power socket. The appliance sounds once, and all indicators flash once.
(Fig. 18)
2 Press the On/off button to switch on the appliance. (Fig. 19)
3 Press the Start/pause button to start the automatic pasta making program. (Fig. 20)
Note: If the appliance is not in the automatic mode, press the Automatic button before
pressing the Start/pause button.
(Fig. 12)
(Fig. 13)
(Fig. 14)
Water Water + Egg