Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
(7) Speaker system connections
• Use speaker cords with twisted wire cores and a diameter of 0.6 to 1.5 mm.
Never use cords thicker than 1.5 mm or single-wire cords, as they may
damage the speaker terminals.
• Be sure to interconnect the polarities of the terminals on the speakers and
main unit (≈ to ≈, √ to √).
• When making connections, be careful that none of the core wires of the
speaker cords stick out and touch neighboring terminals, other speaker cords
or the rear panel.
• Speakers with an impedance of 6 to 16 Ω/ohms can be connected for use as
center and surround speakers.
Connections
• When making connections, also refer to the operating instructions of the other components.
FRONT SPEAKER
SYSTEMS
(L)
14
Connection the speaker terminals
1. Push the lever.
CENTER SPEAKER
SYSTEM
(R)
LOOP
ANT.
FM COAX. 75
AM
IMPEDANCE
R
L
R
6 16
FRONT
CENTER
SURROUND
SPEAKER SYSTEMS
NOTE:
NEVER touch the speaker terminals when the power is on.
Doing so could result in electric shocks.
• The protector circuit may be activated if the set is played for long periods of
time at high volumes when speakers with an impedance lower than the
specified impedance are connected.
2. Insert the cord.
SURROUND
SPEAKER SYSTEMS
(L)
(R)
VIDEO
S VIDEO
MON.OUT
IN
IN
IN
IN
OUT
MON.OUT
TV/DBS
V.AUX
VCR
IN
OUT
IN
IN
IN
L
PRE OUT
R
SUB WOOFER
CDR/
TV/DBS
V.AUX
L
TAPE
AUDIO
3. Return the lever.
SUB WOOFER
Connector jack for subwoofer
with bilt-in amplifier (super
woofer), etc.
COMPONENT VIDEO OUT
IN
OUT
Y
C
B
IN
IN
OUT
VCR
TV/DBS
V.AUX
(OPTICAL)
DIGITAL
• Precautions when
connecting speakers
If a speaker is placed near a
TV or video monitor, the
colors on the screen may
be
disturbed
speaker's magnetism. If
this should happen, move
the speaker away to a
position where it does not
have this effect.
C
R
by
the
Publicité
Chapitres
Table des Matières
