Setting The Speaker Distance - Denon ADV-700 Mode D'emploi

ENGLISH

[2] Setting the speaker distance

• Input the distances from the listening position to the speakers and
set the surround delay time.
• The default settings below are set upon shipment from the factory.
Preparations:
Measure the distances from the listening position to the speakers (L1
to L3 on the diagram at the right).
FL Center FR
L
L
1
2
Listening
position
L
3
SL SR
1 To perform these operations from places other than the
system setting change menu, see page 26.
2 At the SYSTEM SETUP MENU select "DELAY TIME".
Remote control unit
• Switch to the DELAY TIME screen.
S E T T H E D I S T A N C E T O E A C H S P E A K E R S S E T T H E D I S T A N C E T O E A C H S P E A K E R S
U N I T U N I T
DEFAULT DEFAULT
FRONT&SW FRONT&SW
CENTER CENTER
SURROUND SURROUND
SELECT :
• Use the and
"METERS" or "FEET".
Press the cursor button to proceed to the next step if you do
not wish to change this.
3 When "YES" is selected for "DEFAULT", the delay times for
the various speakers are set to the default values.
YES: FRONT & SW / 9ft
B
CENTER / 8ft
SURROUND / 7ft
NO: The current settings are used.
B
28
L : Distance from center speaker to
1
listening position
L : Distance from front speakers to
2
listening position
L : Distance from surround speaker to
3
listening position
ENTER
Remote control unit
B
DELAY TIME
METERS F E E T METERS F E E T
9 f t 9 f t
8 f t 8 f t
7 f t 7 f t
FINISH: ENTER BUTTON
cursor buttons to select the distance unit,
4
Select the speaker to be set using the
buttons, then setting the distance between the speakers and
the listening position using the
• Set the distance between the center speaker and listening position.
The distance changes in units of 1 foot (0.1 meters) each time the
button is pressed. Select the value closest to the measured
distance.
S E T T H E D I S T A N C E T O E A C H S P E A K E R S S E T T H E D I S T A N C E T O E A C H S P E A K E R S
U N I T U N I T
DEFAULT DEFAULT
FRONT&SW FRONT&SW
CENTER CENTER
SURROUND SURROUND
SELECT :
The difference of the distances set for the different speakers must
be no greater than 10 ft (3.0 m).
If an inapplicable distance is set, "CAUTION: INVALID DISTANCE"
is displayed. Change the speaker position and reset.
5 Enter the setting.
• The SYSTEM SETUP MENU reappears.
and cursor
and cursor buttons.
DELAY TIME B
METERS METERS F E E T F E E T
9 f t 9 f t
8 f t 8 f t
7 f t 7 f t
FINISH: ENTER BUTTON
ENTER
Remote control unit