Listening To Preset Stations - Denon ADV-700 Mode D'emploi

POWER
VCR POWER
TV POWER
(3) Presetting FM and AM stations
Example: Presetting FM station (currently tuned in) at preset number P03
MODE
BAND
2
CH
TU
SUB TITLE
PROG/DIRECT REPEAT A-B
CH.SELECT T.TONE
SETUP CDR/MD/TAPE TUNER/TV/VCR
Before operating the remote control unit!
Be sure to press the proper remote control mode selector
button to set the remote control unit to the AV mode.
1
Tune in the broadcast station that is to be preset and press
the Memory button.
• A "P - -" indication flashes for 10 seconds.
NTSC/PAL
Remote control unit
Presetting
• Up to 40 AM or FM stations can be preset using this procedure.
• In addition to the reception frequency, the reception mode (monaural or auto) is also preset, so check the display when presetting stations.
• If a station is preset at a number where a station is already preset, the previous station is replaced with the new station.
• The preset memory is not cleared when the power cord is unplugged.
POWER
VCR POWER

Listening to preset stations

(4)
TV POWER
Example: Listening to the station preset at number P03 (This operation is only possible from the remote control unit.)
MODE
BAND
1
CH
TU
SUB TITLE AUDIO
PROG/DIRECT REPEAT A-B
CH.SELECT T.TONE
SETUP CDR/MD/TAPE TUNER/TV/VCR
ENTER
VOLUME
2
MUTE
SHIFT
NTSC/PAL STATUS
1,3
MEMO
AUDIO ANGLE TOP MENU
REPEAT RANDOM
SDB/TONE SURR.PARA
DVD
TUNER/TV/VCR
MEMO
ENTER
VOLUME
1
MUTE
SHIFT
NTSC/PAL STATUS
MEMO
ANGLE TOP MENU
REPEAT RANDOM
SDB/TONE SURR.PARA
DVD
REMOCON MODE
2
While the "P - -" indication is flashing, use the shift button and
the channel (CH) buttons (–, +) to display the preset number
"P03".
Each press of the shift button adds 10 to the current preset number
in the range of P00 to P40.
Example:
Starting with a P13
setting, each press of
the shift button results
in the changes P13 /
P23 / P33 / P03 /
P13 /...
Example:
Starting with a P00 setting, each press of the shift button results in
the changes P00 / P10 / P20 / P30 / P40 / P10 /...
3
Press the MEMORY button while the "P03" display is
flashing.
• The "P03" display will light and presetting will be
completed.
NTSC/PAL
Remote control unit
Before operating the remote control unit!
Be sure to press the proper remote control mode selector
button to set the remote control unit to the AV mode.
1
Press the remote control shift button and the channel (CH)
button (–, +) and select preset number "P03".
CH
ENGLISH
SHIFT
CH
Remote control unit
MEMO
TUNER/TV/VCR
SHIFT
Remote control unit
53