Denon ADV-700 Mode D'emploi page 70

Ampli-syntoniseur surround dvd
Masquer les pouces Voir aussi pour ADV-700:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
(4) Setting the sleep timer (remote control unit only)
• The included remote control unit can be used to turn the power to the standby mode after a maximum of 120 minutes. (Sleep timer)
• Use this function to automatically switch the power to the standby mode after a specific amount of time (minutes).
Example: To set the power to the standby mode in 50 minutesaccording to the clock. Be sure to correct the current time setting.
1
Select and play the desired function.
2
Press the SLEEP button.
• "120" is displayed and the "SLEEP" indicator flashes.
120
The display switches as follows each time the SLEEP
button is pressed:
120
90
3
When the "SLEEP" indicator is flashing, press the SLEEP
button again until "50" is displayed.
• "50" is displayed and the "SLEEP" indicator flashes.
50
• After 4 seconds, the display returns to as it was before the
sleep timer was set, and the "SLEEP" indicator stops
flashing, remaining lit. (This completes the sleep timer
setting.)
4
The power is set to the standby mode 50 minutes later.
To turn the sleep timer off, press the SLEEP button repeatedly until
the "SLEEP" indicator turns off. The sleep timer can also be turned
off by press the power button on the main unit or the remote
control unit to turn the entire system's power to the standby mode.
70
SLEEP
SLEEP
Remote control unit
60
50
40
30
20
"SLEEP" indicator off
SLEEP
SLEEP
Remote control unit
NOTES:
• If the SLEEP button is pressed while the sleep timer is
operating, the setting returns to 120 minutes. Make the setting
over.
• If the sleep timer and everyday timer settings overlap, the sleep
timer has priority.
Everyday timer
setting
Sleep timer
setting
Timer operation
10
• Also, the everyday timer will not operate if its start time is set
within the time during which the sleep timer is operating.
Everyday timer
setting
Sleep timer
setting
• The remaining time of the sleep timer can be checked with the
STATUS button.
20:00
21:00
ON
+
ON
OFF
If the timers overlap like this, the timer operates as follows:
20:00
21:00
ON
OFF
20:00
21:00
Does not operate
ON
+
ON
OFF
22:00
OFF
22:00
22:00
OFF

Publicité

Chapitres

Table des Matières
loading

Table des Matières