Connections - Denon DRA-295 Mode D'emploi

ENGLISH

5 CONNECTIONS

• Do not plug in the power cord until all connections have been
completed.
• Be sure to connect the left and right channels properly (left
with left, right with right).
• Insert the plugs securely. Incomplete connections will result in
the generation of noise.
• Use the AC OUTLETS for audio equipment only. Do not use
them for hair driers, etc.
Connecting the audio components
PRE OUT jacks
Use these jacks when using
another separate amplifier or a
pre-main amplifier.
LINE IN
Tape deck
R L R L
R L R L
OUTPUT INPUT
Connecting a tape deck
Connections for recording:
Connect the tape deck's recording input jacks
(LINE IN or REC) to this unit's tape recording
(OUT) jacks using pin plug cords.
Connections for playback:
Connect the tape deck's playback output jacks
(LINE OUT or PB) to this unit's tape playback
(IN) jacks using pin plug cords.
6
OUTPUT
R
R
AUDIO VIDEO
R L
IN IN
CD
LOOP
AM
ANT.
L
DVD/
DVD/ VDP
VDP
R
FM
COAX.
V. AUX V. AUX
75
L
VCR
VCR
ANTENNA TERMINALS
R
CDR/
MONITOR
TAPE
OUT
PRE OUT
VCR
VCR
R L
OUT
VIDEO
CDR/
TAPE IN OUT
R L
ROOM TO ROOM (REMOTE CONTROL)
R L
R L
• Note that binding pin plug cords together with power cords or
placing them near a power transformer will result in generating
hum or other noise.
• If hum or other noise is produced when the ground wire is
connected, disconnect it.
• Noise or humming may be generated if a connected
component is used independently without turning the power of
this unit on. If this happens, turn on the power of the this unit.
CD player
L
DIGITAL AUDIO DIGITAL AUDIO
L
Connect the CD player's analog output jacks (ANALOG
OUTPUT) to this unit's CD jacks using pin plug cords.
SPEAKER SYSTEMS
B
R L
SPEAKER IMPEDANCE
A OR B / 4 16
A + B / 8 16
AUX OUT
Another room
RC-617 (Sold Separately)
Infrared sensor
+
OUTPUT
Connecting the AC OUTLETS
AC OUTLETS
• SWITCHED (total capacity – 120 W (1 A.)
The power to this outlet is turned on and off in conjunction with the POWER operation
switch on the main unit, and when the power is switched between on and standby
from the remote control unit.
No power is supplied from these outlets when this unit's power is at standby. Never
connect equipment whose total capacity is above 120 W (1 A.)
NOTE:
Use the AC OUTLETS for audio equipment only. Do not use them for hair driers, etc.
Connecting a CD player
AC CORD
AC 120 V, 60 Hz
AC OUTLETS
AC 120V 60Hz
A
SWITCHED
R L
TOTAL 120W(1A.) MAX.
RC-616 (Sold Separately)
Infrared retransmitter
+
INPUT