Connections - Denon DRA-201SA Mode D'emploi

ENGLISH
4

CONNECTIONS

2 When connecting, also refer to the manuals of the other components.
When connecting to the 201SA series, make the system connections shown by dotted lines on the diagram below.
2
2 The DRA-201SA is not equipped with connection cords. Use the connection cords included with the components you are
connecting to the DRA-201SA.
NOTES:
• Do not plug the power cords into the power outlets until all connections have been completed.
• Check the left and right channels and be sure to interconnect them correctly (R to R, L to L).
• Plug in the power cords securely. Incomplete connections will result in noise.
• Do not clasp the connection cords together with the power cords or place them near other electric products. Doing so may
result in noise.
• The PHONO input jack is extremely sensitive. A booming sound may be produced from the speakers if the volume is turned
up when no turntable is connected.
• The sound of another component may be heard if no component is connected to the input jacks of the function selected
with the FUNCTION selector.
DVD player
B
DVD
R L R L R L L R
INPUTS PB
CD DVD/AUX AUX-2 TAPE MD
L
L
R
AM
LOOP
ANT. R
PHONO TAPE MD
L
ANTENNA
FM COAX. 75
R
SIGNAL
REC
GND
R R
L L R
NOTE:
• This unit cannot be used with MC cartridges directly. Use a head
amplifier or a step-up transformer with MC cartridges.
NOTE:
• If noise is generated
when the ground wire is
Turntable
connected, disconnect
(with MM cartridge)
the ground wire.
6
All manuals and user guides at all-guides.com
Speaker system
CD player
(L) (R)
1 2
SYSTEM
CONNECTOR
L
R
SPEAKER SYSTEM
SPEAKER IMPEDANCE
4 16
L
DIGITAL AUDIO DIGITAL AUDIO
• The 201SA series stereo
receiver (DRA-201SA) is
equipped with a clock and timer
function, so be sure to connect
it to a wall power outlet to
which power is supplied
constantly.
Power plug
AC 230V, 50 Hz
(Plug into a power outlet)
Power cord
(for U.K. model)
• When making system connections with the 201SA series, connect
the system cord to the DRA-201SA system connector (either 1 or 2).
Also interconnect the other system components in the same way.
(System connections are indicated by dotted lines on the diagram.)
MD recorder
(DMD-201SA)
LINE DIGITAL
L OPTICAL
OUT IN
SYSTEM
CONNECTOR
OUT 1 IN 2
L
1 2
R
R
L
R
Cassette deck
(DRR-201SA)
LINE
L
OUT IN
SYSTEM
CONNECTOR
L
1 2
R
R
L
R
CD player
(DCD-201SA)
LINE OUT DIGITAL
L
OPTICAL
SYSTEM
CONNECTOR
1 OUT 2
L
R 1 2
R
NOTE:
• To allow for heat dispersal, do
not place another component
or any other object directly on
top of the DRA-201SA.
Power plug
AC 230V, 50 Hz
(Plug into a power
outlet)
Power cord
(for U.K. model)
Power plug
AC 230V, 50 Hz
(Plug into a power
outlet)
Power cord
(for U.K. model)
Power plug
AC 230V, 50 Hz
(Plug into a power
outlet)
Power cord
(for U.K. model)