Denon DRA-201SA Mode D'emploi page 10

ENGLISH
(2) Using the Remote Control Unit
Approx. 7m
30°
30°
NOTES:
• The remote control unit may not work properly if the
remote sensor is exposed to direct sunlight or
strong artificial light or if there is an obstacle
between the remote control unit and the remote
sensor.
• Do not press the buttons on the main unit and the
remote control unit at the same time. Doing so will
result in malfunction.
10
All manuals and user guides at all-guides.com
• Point the remote control unit at the remote sensor on
the main unit as shown on the diagram when operating
it.
(When system connections are made, the remote
control signals for all the system components are
received at the DRA-201SA remote sensor.)
• The remote control unit can be used from a straight
distance of about 7 meters, but this distance will be
shorter if the there is an obstacle in the way or if the
remote control unit is not pointed directly at the remote
sensor.
• Use the remote control unit within a range of 30° to the
left and right of the remote sensor.
(3) Names and Functions of Remote Control Unit Buttons
Opening the remote control unit's cover
2
RDS button
Use this button to automatically tune to stations using
the radio data system.
RDS PTY TP
Press the PRESET < or > button after selecting
"PTY" with the RDS button to select one of the 29
program type.
PANEL button
This button is used to select the panel mode.
Press this button when receiving RDS stations to
select the frequency, PS, PTY, RT or CT display.
The display mode changes as follows each time the
button pressed.
PS PTY RT CT Frequency
CT display
Use this to correct the time of the clock on the DRA-
201SA. Press the PANEL button when the time
service of an RDS station is being properly received.
"CT" and "TIME" are displayed and the DRA-
201SA's clock is corrected. "NO CT" is displayed if
the RDS station does not offer a time service and
when the broadcast is not being received properly.
Note that this button will not function if the reception
is poor.