EINHELL TC-PG 1000 Instructions D'origine page 21

10. Troubleshooting
Fault
Engine does not
start
Generator has too
little or no
voltage
Anl_TC_PG_1000_SPK9.indb 21 Anl_TC_PG_1000_SPK9.indb 21
GB
Possible cause
Automatic oil cut-out has not
responded
No fuel
Controller or capacitor defective
Overcurrent circuit-breaker has
triggered
Air fi lter dirty
- 21 -
Remedy
Check the oil level, top up with engine
oil
Refuel
Contact your dealer
Actuate the circuit-breaker and
reduce the consumers
Clean or replace the fi lter
25.01.2018 11:55:40 25.01.2018 11:55:40