Connection Of Bus Function Module - Lenze starttec E71MM402 Instructions De Montage

5
Electrical installation

Connection of bus function module

You can operate the starttec via FIF interface at the following bus systems:
Bus system
PROFIBUS−DP
INTERBUS
System bus (CAN)
DeviceNet
CANopen
LECOM−B (RS485)
)
Note!
The mounting of an FIF module requires the mounting set E71ZJ001!
l
Observe the mounting instructions accompanying the mounting set.
–
Notes about the wiring of the bus function module can be found in the
l
mounting instructions accompanying the bus function module.
(
Stop!
During the operation with starttec, terminal 28 (controller inhibit) of the
function module is inactive! Release/inhibit is switched via terminal 28 of the
starttec.
98
Required Lenze FIF module
E82ZAFPC 001
E82ZAFIC 001
E82ZAFCC 001
E82ZAFVC 001
E82ZAFUC 001
E82ZAFLC 001
EDK71MMXXX−020 DE/EN/FR 5.0
L