Lenze starttec E71MM402 Instructions De Montage page 113

Code
No. Designation
C0002 Restore delivery
s
state
uSEr
(Cont.)
Transfer
parameter sets
with keypad
L
Setting options
Lenze Selection
1
Lenze setting
2
Lenze setting
3
Lenze setting
4
Lenze setting
31
Lenze setting
61
Lenze setting
62
Lenze setting
61
Lenze setting
62
Lenze setting
Keypad
70 with function module INTERBUS,
PROFIBUS−DP, LECOM−B,
DeviceNet/CANopen
10 with all other function modules
Keypad
71 with function module INTERBUS,
PROFIBUS−DP, LECOM−B,
DeviceNet/CANopen
11 with all other function modules
Keypad
72 with function module INTERBUS,
PROFIBUS−DP, LECOM−B,
DeviceNet/CANopen
12 with all other function modules
EDK71MMXXX−020 DE/EN/FR 5.0
Commissioning
ð
PAR1
ð
PAR2
ð
PAR3
ð
PAR4
ð
FPAR1
ð
PAR1 + FPAR1
ð
PAR2 + FPAR1
ð
PAR3 + FPAR1
ð
PAR4 + FPAR1
ð
drive controller
ð
PAR1 (+ FPAR1)
ð
PAR2 (+ FPAR1)
7
Code table
IMPORTANT
Restore delivery state in the
selected parameter set of
the drive controller
Restore delivery state in the
fieldbus function module
Restore delivery state in the
selected parameter set of
the drive controller and in
the fieldbus function
module
You can use the keypad to
transfer parameter sets to
other drive controllers.
During the transfer,
access to the parameters
via other channels is
inhibited!
Overwrite all available
parameter sets
(PAR1 ... PAR4, if necessary
FPAR1) with the
corresponding data of the
keypad
Overwrite the selected
parameter set and FPAR1, if
necessary, with the
corresponding data of the
keypad
113