Troubleshooting Guide; Corrective Action - Hatco Thermo-Finisher TFWM Série Manuel D'installation Et D'utilisation

English
WARNING
This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
Symptom
Unit is not working at all.
Unit is turned on but there is
no heat.
Heat inadequate.
Excessive heat.
Troubleshooting Questions?
If you continue to have problems resolving an issue, please contact the nearest Authorized Hatco Service Agency or Hatco
for assistance. To locate the nearest Service Agency, log onto the Hatco website at www.hatcocorp.com and click on
Find Service Agent, or contact the Hatco Parts and Service Team at:
Telephone: 800-558-0607 or 414-671-6350
Form No. TFWMM-0817
Probable Cause
Unit not turned on.
Unit not plugged in.
Circuit breaker tripped.
POWER ON/OFF (I/O) switch is defective.
Voltage supply incorrect.
No plate/tray on adjustable shelf or plate/tray
too light.
No power to unit.
POWER ON/OFF (I/O) switch is defective.
HEAT CONTROL infinite switch(es) defective. Contact Authorized Service Agent or Hatco for assistance.
Ribbon heating element(s) defective.
HEAT CONTROL knobs set too low.
HEAT CONTROL infinite switch(es) defective. Contact Authorized Service Agent or Hatco for assistance.
Ribbon heating element(s) defective.
Voltage supply too low.
HEAT CONTROL knobs set too high.
HEAT CONTROL infinite switch(es) defective. Contact Authorized Service Agent or Hatco for assistance.
Voltage supply too high.
e-mail: partsandservice@hatcocorp.com

TROUBLESHOOTING GUIDE

ELECTRIC SHOCK HAZARD: Turn OFF power switch and
disconnect unit from power source before performing any
cleaning, adjustments, or maintenance.
Move POWER ON/OFF (I/O) switch to the ON (I) position.
Plug unit into proper power supply.
Reset circuit breaker. If circuit breaker continues to trip,
Contact Authorized Service Agent or Hatco for assistance.
Contact Authorized Service Agent or Hatco for assistance.
Check power supply to unit, making sure it matches rating
on the unit. If power supply is incorrect, change to match
rating on unit.
Place plate/tray on adjustable shelf or use heavier plate/tray
to activate ribbon heating element.
Make sure unit is plugged in and/or check circuit breaker and
reset as necessary.
Contact Authorized Service Agent or Hatco for assistance.
Contact Authorized Service Agent or Hatco for assistance.
Turn the HEAT CONTROL knobs to a higher setting.
Contact Authorized Service Agent or Hatco for assistance.
Check power supply to unit, making sure it matches rating
on the unit. If power supply is incorrect, change to match
rating on unit.
Turn the HEAT CONTROL knobs to a lower setting.
Check power supply to unit, making sure it matches rating
on unit. If power supply is incorrect, change to match rating.
13
WARNING

Corrective Action