Indexa DVT30 Mode D'emploi page 49

[93] - Brightness of the image
If required the brightness of the image can be adjusted.
!
Press the brightness button to adjust the brightness, which is represented in bars.
Default setting: 2 bars
[94] - Activate / deactivate cameras 2-4
!
Press the activation button to activate (ON – image of the paired camera will be shown) or to deactivate (OFF – image of the paired camera will
not be shown).
Default: cameras 2-4 OFF
Note:
#
Camera 1 cannot be deactivated, it is always active.
#
The image from a paired camera which is deactivated will not be displayed nor will it be recorded.
[82] - RECORDER SETUP(see Fig. G)
[95] - 24 hour RECORD SCHEDULE (Select time and method of recording)
This time plan is valid for all cameras and for every day.
!
To set the same recording schedule for all 4 cameras,
#
M=MOTION: cameras 2-4 can be recorded automatically upon motion detection, manual recording of all 4 cameras is also possible (only
activated cameras 2-4 can detect motion, the camera in the outdoor station does not have this function)
#
S=SCHEDULE: all four cameras can be recorded continuously
#
X= MANUAL recording can be started only by pressing the record button
!
To set the recording type for each individual hour period,
period [100] by repeated pressing:
#
M= cameras 2-4 can be recorded automatically upon motion detection during the hour period, manual recording of all 4 cameras is also
possible
#
S=SCHEDULE: all four cameras can be recorded continuously during the hour period
#
X= MANUAL recording can be started only by pressing the record button
Default: all cameras can be recorded manually only, for all 24 hours.
Notes:
#
Motion is detected by software analysis of pixel changes within the activated areas of the camera image.
#
Recordings can only be made from activated cameras.
#
During recording the symbol [5] indicates which camera also has audio recording. For the recording of audio from additional cameras it is
important, which image is selected: If quad or full image of the outdoor station selected, the audio from the outdoor station will be recorded
the speech button [17] is activated
detection activated recordings the audio is recorded from the camera which triggered the recording.
#
The recording period after motion detection is approx. 2 minutes. Continuous recording is made in files of 10 minutes, ie. During one hour period
there will be 6 recordings each of 10 minutes length. Note that if the ring recording is deactivated no further recordings can be made when the
micro-SD card has reached its capacity.
#
If continuous or motion detection recording has been set, then after exiting the menu the message "REC RESUMES IN 4 SEC" indicates that
recording is possible after a setting period of 4 seconds.
#
When a recording begins a message appears "REC IN PROCESS WAIT 14 SEC". Only after 14 seconds have elapsed can the recording be manually
stopped.
#
To stop a continuous or motion detection recording, open the control bar by pressing the [15] symbol, press the record button [21] and then
immediately afterwards the menu button [22]. Now you are in the main menu. and can change the recording settings. If you leave the main menu
without changing the settings, the recording will recommence immediately.
#
During recording (flashing red dot [9]) it is not possible to open the main menu. To open the menu proceed as in the previous note.
#
During continuous or motion detection recording the manual Zoom function is not available.
[96] - MOTION DETECTION SENSITIVITY
For each camera 2-4 you can select how sensitive the pixel changing must be to trigger a recording.
Default: cameras 2-4: 2 bars
press [99] in the top bar.
firstly select X=MANUAL [99]. Now you can select the recording type for each hour
. If the full image of a camera 2-4 is selected, then the audio of the selected camera will be recorded. For motion
when
GB - 49