Ryobi EAG-8512R Manuel D'utilisation page 7

GB
FR DE ES
ANGLE GRINDER SAFETY PRECAUTIONS
Always use protective safety glasses and ear
Q
protectors.
Use other personal protective equipment such as
Q
gloves, apron and helmet when necessary.
Never place the tool on the floor or other surfaces while
Q
it is running. Grinding wheels continue to rotate after
the tool is switched off. Never touch the wheel or place
it on the floor or other surfaces while it is rotating.
The flange and clamp nut must have same outer
Q
diameter.
Use the tool only for approved applications. Never use
Q
coolants or water or use the tool as a fixed tool.
Grip the tool securely with both hands while operating.
Q
SPECIFICATIONS
Model
Grinding wheel
Frequency
Voltage*
Input
Spindle thread
Rated speed
Net weight
* Be sure to check the nameplate on the product,
because the voltage is subject to change depending
on the area in which the product is to be used.
Maximum circumferential speed of grinding wheel:
4,800 m/min.
Example of calculation:
4,320 = 3.14 x 125 x 11,000 / 1,000
4,320: Circumferential speed of grinding wheel
125: Wheel diameter
11,000: No load speed of grinder
DESCRIPTION
1. Grinding wheel
2. Tool-less wheel guard
3. Aux. handle
4. Rotary handle lock button
5. ON / OFF switch
6. Lock-off button
7. Disc flange
8. Clamp nut
9. Spindle shaft
10. Wrench
11. Spindle lock button
12. Wheel guard lock lever
IT NL PT DK SE
EAG-8512R
125 mm (5")
50 Hz
230 V
850 W
M14
-1
11000 min.
2.8 kg
FI NO RU PL CZ
English
13. Live tool indicator
STANDARD ACCESSORIES
Aux. handle (3).
A grinding wheel is included in the standard accessories
for some countries.
APPLICATION
Use only for the purpose listed below:
- Grinding
NOISE BUILD-UP
Noise (sound pressure level) in the workplace can exceed
85 dB (A). In this case, sound insulation and hearing
protection measures must be taken by the operator.
ON / OFF SWITCH
To switch on the unit – use your finger to push in the lock-
off button (6) and depress the on / off switch (5).
MAIN HANDLE
The main handle can be set to any of three positions
(0 and 90 degree right and left) by pressing the rotary
lock button (4).
TOOL-LESS WHEEL GUARD
Release the wheel guard lock lever (12) then turn
the tool-less wheel guard (2) to the desired position.
The max. turning axle is 90º on either side; otherwise the
guard can't be locked.
MOUNTING THE GRINDING WHEEL
Attach the disc flange (7), the grinding wheel (1) and
Q
the clamp nut (8) to the spindle shaft (9).
Be sure that the disc flange is properly seated on the
Q
spindle shaft.
Depress the lock button (11) located on the right side
Q
of gear case.
Using the wrench (10) provided, tighten the clamp nut
Q
in a clockwise direction.
WARNING
Check carefully whether or not there are
cracks in the wheel. Replace a cracked wheel
immediately.
4
HU RO LV LT EE HR SI SK GR TR