Wilo Control EC-L Notice De Montage page 90

en
90
Commissioning
Current switching state of the float switch
Switchgear running time
The time* is stated depending on the unit, in minutes (min), hours
(h) or days (d).
Running time: Pump 1
The time* is stated depending on the unit in minutes (min), hours (h)
or days (d). The display varies, depending on the timespan:
▪ 1 hour: Display in 0 ... 59 minutes, unit: min
▪ 2 hours to 24 hours: Display in hours and minutes, separated by a
decimal point, e.g. 10.59, unit: h
▪ 2 days to 999 days: Display in days and hours, separated by a
decimal point, e.g. 123.7, unit: d
▪ From 1000 days: Display in days, unit: d
Running time: Pump 2
The time* is stated depending on the unit in minutes (min), hours (h)
or days (d).
Running time: Pump 3
The time* is stated depending on the unit in minutes (min), hours (h)
or days (d).
Switchgear switching cycle
Switching cycles: Pump 1
Switching cycles: Pump 2
Switching cycles: Pump 3
Serial number
Display switches between the 1st and 2nd four digits.
Switchgear type
Software version
Set value for the motor current monitoring value: Pump 1
max. rated current in A
Set value for the motor current monitoring value: Pump 2
max. rated current in A
Set value for the motor current monitoring value: Pump 3
max. rated current in A
Current rated current of pump 1 in A
display changes between L1, L2 and L3
press and hold the operating button. The pump starts after 2 s of
pumping operation until the operating button is released.
Current rated current in A for pump 2
display changes between L1, L2 and L3
press and hold the operating button. The pump starts after 2 s of
pumping operation until the operating button is released.
WILO SE 2018-12