Menu Control; Menu Type: Main Menu Or Easy Actions Menu; Call Up The Menu; Quick Access To "Easy Actions - Wilo Control EC-L Notice De Montage

en
5
Extern OFF
Fig. 27: Illustration of the switching points with
a level sensor in the "fill" operating mode using
the example of one pump
7.3

Menu control

Fig. 28: Operating button function
7.4 Menu type: Main menu or Easy Ac-
tions menu
7.5

Call up the menu

7.6

Quick access to "Easy Actions"

76
Operation
Level measurement with level sensor or dynamic pressure bell
1 Pump On
3
2 Pump Off
2
3 High water level
4 Min. water level
1
5 Dry-running level in the well
4
A level sensor or dynamic pressure bell can be connected. This can be used to control
three pumps:
▪ Pump 1 On/Off
▪ Pump 2 On/Off
▪ Pump 3 On/Off
▪ Min. water level in the tank to be filled
▪ High water level
▪ Dry-running level in the well (separate float switch at the "Extern OFF" input)
The menu is controlled via the operating button:
▪ Turn: Menu selection or settings values.
▪ Press: Change menu level, confirm error number or value.
There are two different menus.
▪ Main menu: Access to all settings for a complete configuration.
▪ Easy Actions menu: Quick access to certain functions.
Observe the following points when using the Easy Actions menu:
– The Easy Actions menu only offers access to the selected functions. It is not possible
to perform a complete configuration with this.
– Perform an initial configuration to use the Easy Actions menu.
– The Easy Actions menu is enabled at the factory. Note, the Easy Actions menu can be
disabled in menu 7.06.
Call up the main menu
1. Press operating button for 3 seconds.
▶ Menu item 1.00 appears.
Call up the Easy Actions menu
1. Turn operating button 180°.
⇒ The "Resetting error messages" or "Manual operation pump 1" function ap-
pears
2. Turn operating button an additional 180°.
▶ The other functions are shown. The main screen appears at the end.
The following functions can be called up using the Easy Actions menu:
WILO SE 2018-12