Start Initial Configuration - Wilo Control EC-L Notice De Montage

1
5
4
3
Fig. 29: Start screen: Level sensor/dynamic
pressure bell
1
5
4
3a 3b 3c 3d
Fig. 30: Start screen: Float switch
8.5

Start initial configuration

Installation and operating instructions Wilo-Control EC-L
Commissioning
▶ The switchgear is ready for operation, start the initial configuration or automatic
mode.
Display with level sensor or dynamic pressure bell
Current pump status:
– Number of registered pumps
2
1
– Pumps activated/deactivated
– Pumps On/Off
2 Set operating mode (e.g. drain)
3 Current water level in m
4 Standby: Switchgear is ready for operation.
5 Field bus active
Display with float switch
Current pump status:
– Number of registered pumps
2
1
– Pumps activated/deactivated
– Pumps On/Off
3 2 Set operating mode (e.g. fill)
3 Switching state of the float switch
3e
4 Standby: Switchgear is ready for operation.
5 Field bus active
Switching state of the float switch depending on the operating mode
No. drain
High water level
3a
Pump 2 On
3b
Pump 1 On
3c
Pump 1 and 2 Off
3d
Dry-running level
3e
Observe the following points during the configuration:
▪ If there is no input or operation for 6 minutes:
– The display illumination is switched off.
– The display shows the main screen again.
– Parameter input is locked.
▪ Some settings can only be changed when all pumps are off.
▪ The display illumination switches off automatically if not operated for one minute.
▪ The menu adapts automatically, based on the settings. Example: Menu 1.12 is only vis-
ible if the level sensor has been activated.
▪ The menu structure applies to all EC switchgears (e.g. EC-Lift, EC-Fire). This may lead
to gaps in the menu structure.
As standard, the values are only displayed. To change values, the parameters in menu
7.01 must be enabled:
fill
High water level
Pump 1 and 2 Off
Pump 1 On
Pump 2 On
Min. level (low water)
en
79