Brother QL-650TD Guide De L'utilisateur page 12

8
Introduction
Cutter unit
• The cutter unit contains a very sharp blade. To
prevent injury from a broken cutter blade:
• Make sure the top cover is closed when using the
cutter unit.
• Don't apply too much pressure when fitting or
removing the cutter unit.
• When the cutter unit becomes blunt you should
replace it with a new one.
• If you break the cutter unit, unplug your printer
from the power and remove the cutter unit
carefully with a pair of tweezers.
• If the machine jams due to a build up of adhesive, you
should clean the surface of the paper guide. Unplug
the printer from the power and wipe away the
adhesive build up from the surface of the paper guide
using a cloth or tissue dipped in isopropyl alcohol. We
recommend that you clean the paper guide when replacing the cutter unit.
• The cutter unit should give you an average number of 5000 cuts or more, depending on how you
use the machine. If your printer does not cut the labels properly or starts to jam often, the cutter
might have reached the end of its life; you should replace the cutter.
Paper guide serface