General Precautions - Brother QL-650TD Guide De L'utilisateur

6
Introduction

General Precautions

The Printer
•
The printer is a precision machine. Do not drop, hit or otherwise bang the printer.
•
Do not lift the printer by the DK Roll compartment cover. The cover could come off and
the printer could fall and become damaged.
•
The printer may malfunction if left near a television, radio, etc. Do not use the printer near
any machine that can cause electromagnetic interference.
•
Do not expose the printer to direct sunlight or near heaters or other hot appliances, in
any location exposed to extremely high or low temperatures, high humidity or dusty
locations. Doing so could cause the machine to malfunction.
•
Do not use paint thinner, benzene, alcohol or any other organic solvents to clean the
printer. Doing so may cause damage to the surface finish. Use a soft, dry cloth to clean
the printer.
•
Do not place any heavy objects or objects containing water on top of the printer. If water
or any foreign object enters the printer, contact the retail outlet where the printer was
purchased or your local authorized service center. If you continue to use the printer with
water or a foreign object in the printer, the printer may be damaged or personal injury
could result.
•
Do not touch the cutter. Personal injury could result. Take special care when changing
the cutter unit.
•
Do not insert any objects into or block the label output slot, USB port, or serial port.
•
Do not place any metal parts near the print head. The print head becomes very hot
during use and remains very hot immediately after use. Do not touch it directly with your
hands.
•
Use only the interface cable (USB cable) included with the printer.
•
When not in use for an extended period, remove the DK Roll from the printer.
•
Do not attempt to print labels while the DK Roll cover is open.
•
Never disassemble the printer or allow it to get wet to avoid possible fire or electrical
shock. Do not remove the power cord from or insert it into the electrical outlet with wet
hands. Doing so could cause an electrical shock or fire.
•
If a paper jam should occur due to a build up of adhesive on the paper guide surface,
unplug the power cord from the electrical outlet and wipe away the adhesive buildup on
the paper guide surface with a cloth dipped in ethanol or isopropyl (rubbing) alcohol. It is
recommended that you clean the paper guide when replacing the cutter unit.
•
The serial connector on the QL-650TD side is not Limited Power Source.
Power Cord
• Use only the AC power cord included with the printer.
• If the printer will not be used for an extended period, remove the power supply cord from the
electrical outlet.
• Always hold the plug when removing the power cord from or inserting it into the outlet. Do not pull
on the cord. The wire in the cord may become damaged.
• You should position the printer near an easily accessible, standard electrical socket.
DK Roll (DK Label and DK Tape)
•
Use only genuine Brother accessories and supplies (with
unauthorized accessories or supplies.
•
If the label is attached to a wet, dirty, or oily surface, it may peel off easily. Before
applying the label, clean the surface to which the label will be applied.
•
DK Roll uses thermal paper and thermal film so that ultraviolet rays, wind, and rain may
cause the colour of the label to fade and the ends of the label to peel off.
•
Do not expose the DK Rolls to direct sunlight, high temperatures, high humidity, or dust.
Store in a cool, dark place. Use the DK Rolls soon after opening the package.
marks). Do not use any
,