Brother QL-650TD Guide De L'utilisateur page 11

•
Scratching the printed surface of the label with your finger nails or metal objects, or
touching the printed surface with hands dampened by water, sweat, or medicated cream,
etc., can cause the colour to change or fade.
•
Do not apply labels to any persons, animals, or plants.
•
As the end of the DK Roll is designed to not adhere to the label spool, the last label may
not be cut properly.If this happens, remove the remaining labels, insert a new DK Roll,
and reprint the last label.
Note: To account for this, the number of DK Labels included on each DK Roll may be
more than indicated on the package.
•
When peeling a DK Label, some portion of the label may remain. Remove the remaining
portion before attaching a new label.
•
Some DK Rolls use permanent adhesive for their labels. These labels cannot be easily
peeled off once attached.
•
Prior to using CD/DVD labels, be sure to follow the instructions in your CD/DVD player's
instruction manual regarding applying CD/DVD labels.
•
Do not use CD/DVD labels in a slot loading CD/DVD player, for example a CD player in
a car where the CD is slid into a slot in the CD player.
•
Do not peel off the CD/DVD label once it is applied to the CD/DVD, a thin surface layer
may come off, resulting in damage to the disk.
•
Do not apply CD/DVD labels to CD/DVD disks designed for use with ink jet printers.
Labels peel off these disks easily and using disks with peeled labels can result in loss or
damage of data.
•
When applying CD/DVD labels, use the applicator included with the CD/DVD label rolls.
failure to do so could cause damage to the CD/DVD player.
•
User's shall take full responsibility for applying CD/DVD labels. Brother accepts no
responsibility for any loss or damage of data caused by the inappropriate use of CD/DVD
labels.
CD-ROM and Software
• Do not scratch or subject the CD-ROM to high or low temperatures.
• Do not put heavy objects on the CD-ROM or apply force to the CD-ROM.
• The software contained on the CD-ROM is meant for use with the printer only. See License on CD
for further details. This software may be installed on multiple personal computers for use in an
office, etc.
Battery
•
Do not use the battery in any other products.
•
Dispose of a used battery in accordance with all applicable
federal, state, and local regulations.
•
When storing or discarding the battery, wrap it with
adhesive cellophane tape or similar material. to prevent
short circuit of the battery.
•
It is recommended to replace the battery every two years.
FRANÇAIS
Example of grounding of battery
Adhesive cellophane tape etc.
Battery
7
STEP
1
STEP
2
STEP
3
STEP
4