Cleaning And Maintenance; Storage; Disposal; What If There Are Problems - Beurer TL 41 Touch Mode D'emploi

9. Cleaning and maintenance

The device should be cleaned from time to time.
IMPORTANT
• Ensure that no water gets inside the device!
The device must be switched off, disconnected from the mains and allowed to cool down each time
before cleaning.
• Do not clean the device in a dishwasher!
Use a slightly damp cloth to clean the device.
• Do not use any abrasive cleaning products and never submerge the device in water.
• Do not touch the device with wet hands when it is plugged in and do not allow water to spray on the
device. Only operate the device if it is completely dry.

10. Storage

If you are not going to use the device for an extended period of time, disconnect it and store it in a dry place, out
of the reach of children.
Follow the storage instructions provided in the "Technical data" chapter.

11. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its
service life.
Dispose of the device at a suitable local collection or recycling point in your country. Dispose of the
device in accordance with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you
have any questions, please contact the local authorities responsible for waste disposal.

12. What if there are problems?

Problem Possible cause
Device does Device is switched off
not light up
No electricity
No electricity
LEDs have reached the end of their ser-
vice life.
LEDs faulty.
Solution
Touch the ON/OFF sensor to switch on the device.
Insert the power adapter into a suitable socket.
The mains cable is defective. Contact Customer
Services or your retailer.
For repairs, please contact Customer Services or
an authorised retailer.
16