Haverland RC-A Série Manuel D'installation Et Utilisation page 19

MAINTAINANCE
This thermal transmitter does not need any special maintenance.
Dust it with a dry and soft cloth ONLY WHEN THE TRANSMITTER IS DISCONNECTED AND IS
COLD.
NEVER USE DISOLVENTS OR ABRASIVE PRODUCTS.
We recommend to clean the surface of the transmitter at the beginning of the heating season
(ALWAYS BEFORE SWITCHING IT ON).
At the end of the heating season, it recommended to switch the transmitter off turning the output switch
selector in position 0.
Besides this, once the heating season is over, to unplug the transmitter from the socket.
POSSIBLE INCIDENTS
• THE TRANSMITTER DOES NOT HEAT UP. Please check that the transmitter is not covered or the
air entrances are not obstructed.
• THE TRANSMITTER DOES NOT HEAT UP ENOUGH. Please check that temperature chosen with
the room temperature selector is the desired one. If the selector knob is placed at maximum position
and the appliance is not stilll heating enough, it is possible that room needs a higher heating powder.
ELECTRICAL DIAGRAM
Marsan Industrial SA reserves the right to make any modification without previous warning.
m00r@A2004
Emissión:
ELECTRICAL COMPONENTS
B CONNECTIONS DIAGRAM
C SWITCH
TE ELECTRONIC THERMOSTAT
TS SAFETY THERMOSTAT
P LIGHT
RC RESISTANCE
19