Manufacturer's Warranty - REMS Cento Instructions De Service

eng
3. Operation
Caution, Danger of injury!
Keep hair, clothing and gloves away from the pipe rest when a pipe is
rotating in the rollers. Loose clothing, jewellery or long hair could get
caught between the rotating pipe and the rollers.
3.1. Work Procedure
Mark the cut on the pipe. Move the cutting wheel drive (1) far enough
up or down by turning the feed lever (6) to allow the pipe to be cut (5)
to be inserted in the pipe rest. Remove external burr (sawing burr) to
avoid damaging the rollers.
Caution: Support longer pipes (see 3.2.).
Press the foot switch (8) and cut the pipe with moderate feed by turning
the feed lever (6).
Caution: The cut pipe sections can fall to the floor immediately after
being cut!
3.2. Supporting the Material
Longer pipes must be supported by the REMS Herkules (Art. No. 120100)
on both sides of the machine if necessary.
4. Maintenance
Pull out the mains plug before carrying out maintenance and repair work!
This work may only be performed by qualified personnel and instructed
persons.
4.1. Maintenance
Keep the rollers of the pipe rest (3) clean. Lubricate the feed spindle and
guides of the cutting wheel drive (1) lightly from time to time. The REMS
Cento gear runs with a life-long grease filling and does not need lubri-
cation.
4.2. Inspection / Service
The motor has carbon brushes. These wear out and must be inspected
and replaced by an authorized REMS service workshop from time to
time. See also 5. Behaviour in the Event of Faults.
5. Behaviour in the Event of Faults
5.1. Fault
Pipe cutting machine stops during operation.
Cause
Feed pressure too high.
•
Blunt cutting wheel.
•
Worn carbon brushes.
•
5.2. Fault
Pipe stops during cutting.
Cause
Pipe not round or not deburred on the outside.
•
Rollers of the pipe rest soiled.
•
5.3. Fault
Pipe not cut.
Cause
Unsuitable cutting wheel.
•
Pipe not round or not deburred on the outside.
•
Cutting wheel damaged.
•
5.4. Fault
Pipe cutting machine does not start.
Cause
Defective connecting cable.
•
Defective device.
•

6. Manufacturer's Warranty

The warranty period shall be 12 months from delivery of the new product
to the first user but shall be a maximum of 24 months after delivery to the
Dealer. The date of delivery shall be documented by the submission of
the original purchase documents, which must include the date of purchase
and the designation of the product. All functional defects occurring within
the warranty period, which clearly the consequence of defects in produc-
tion or materials, will be remedied free of charge. The remedy of defects
shall not extend or renew the guarantee period for the product. Damage
attributable to natural wear and tear, incorrect treatment or misuse, failure
to observe the operational instructions, unsuitable operating materials,
excessive demand, use for unauthorized purposes, interventions by the
Customer or a third party or other reasons, for which REMS is not res-
ponsible, shall be excluded from the warranty.
Services under the warranty may only be provided by customer service
stations authorized for this purpose by REMS. Complaints will only be
accepted if the product is returned to a customer service station autho-
rized by REMS without prior interference in an unassembled condition.
Replaced products and parts shall become the property of REMS.
The user shall be responsible for the cost of shipping and returning the
product.
The legal rights of users, in particular the right to claim damages from the
Dealer, shall not be affected. This manufacturer's warranty shall apply only
to new products purchased in the European Union, in Norway or Swit-
zerland.
eng