Command Set Of Parameterization Software; Error Messages / Operating State (Led Display) - HBM PACEline CMD600 Manuel D'emploi

CMD600

7.2 Command set of parameterization software

The complete command set can be found as a PDF file on the accompanying
CD-ROM or downloaded from www.hbm.com/support.
8

Error messages / Operating state (LED display)

CMD600 state LED display
IP address not Green-blue,
configured
Connection via Constant blue
Ethernet
Measure Constant green
Reset Constant red
Overload Red-green or
red−blue, flash-
A2781−2.1 en/de/fr
Device IP address of fac-
flashing tory setting is loaded
Charge amplifier ready for
measurement.
Charge amplifier ready for
measurement
Not ready for
measurement, charge
amplifier in RESET mode
More charge output by
sensor than indicated by
ing the measuring range set
on the CMD600
Note
Match IP addresses of target de-
vice (Host) and charge amplifier
During operation: Toggle Reset/
During operation:
Relieve system
During setting mode:
Check and edit scaling
33
Remedy
−
−
Operate signal