Software For Parameterizing The Cmd600 - HBM PACEline CMD600 Manuel D'emploi

31
CMD600
7

Software for parameterizing the CMD600

You can implement the following settings with the "CMD Assistant" software:
• Entering the sensitivity and measuring range of the channel
• Setting the charge amplifier to Reset or Measure mode
• Selecting display options: Min., max., peak-to-peak
• Scaling an analog output signal
• Automatic scaling via SensorTeach
• Options for the low-pass and high-pass filters
• Functionality of the digital inputs/outputs
• Select parameter sets in the device
• Saving parameter sets to PC and loading them from the PC to the CMD600
• Measured value recording on PC
• Start strip chart and record measurement on PC (host). Load and evaluate
existing measurements.
Storage of all settings in the CMD600 is power fail safe. The settings can also
be saved in a file (parameter set) and loaded back to the CMD600 when
necessary.
The data can also be loaded into the CMD600 Assistant and changed if
necessary for offline parameterization the CMD600.
CAUTION
Only one CMD600 connection can be set up at a time. To simultaneously
operate several devices and display measurement data, CMD Assistant has
to be started multiple times and each time connected to a CMD600.
The Ethernet connection (pear−to−pear) requires use of a Cross cable;
otherwise it will not be possible to select an Ethernet network card in
CMD Assistant or to establish a connection to the CMD600.
NOTE
You can find a more detailed description of the software in the online help
"CMD600Assistant".
A2781−2.1 en/de/fr