Digital Input/Output - HBM PACEline CMD600 Manuel D'emploi

14

3.5 Digital input/output

Digital input 1
− Activation
− Invert circuit logic
− Operating mode
Delete peak-value memory (Min and Max values)
Stop analog output signal (RUN/HOLD)
Parameter set selection (starting with firmware 3.1); see also section 1.3
Digital output 1 and 2
− Activation
− Operating mode
Limit value
Overload
Manual mode
Device error
− Invert circuit logic
For digital output 2 only:
Parameter set selection
running
enable the digital input
refers to the operating mode;
Example: Delete peak-value memory at
high or low signal
"Parameter Sets"
enable the digital output
Output active when limit value exceeded
Output active with overload or
overload of charge amplifier
Output manual switch on or off
Output active with device error
refers to the operating mode
Output active during internal switching of
parameter sets in the device
starting with firmware 3.1
CMD600
A2781−2.1 en/de/fr