Liability Exclusion; Operating Elements; Commissioning, Operation; Switching The Unit On - Renfert Vario E Mode D'emploi

3.2 Safety Information
• The Vario E is an electrical device
with potential hazards. This unit may
only be locked and used by autho-
rized specialist personnel after an ex-
amination with regard to conformity
with applicable national standards.
• Before starting the unit, compare the
information on the nameplate with
the specifications of your local power
supply.
• Do not operate the unit with damaged
power cords or other defects.
• During operation, always unroll the
power cord (overheating hazard in
case of a short circuit).
• Liquid waxes can cause burns. Do
not move the unit during operation!
• During operation, the wax pots are
heated up to their rims. Improper use
or handling can result in burns even
approx. within 30 minutes after power
off.
• The Vario E is designed to be used
exclusively in conjunction with com-
mercially available dental waxes.
Never use the unit to heat other types
of materials!
• Please note: Overfilled pots can spill
over!
• Do not use this device with materi-
als whose flash point is below 175 °C
(347 °F). Keep away any flammable
materials from the hot surface of de-
vice.
• Do not rinse or dip into water. Haz-
ardous voltage can cause electric
shock!
• It is the responsibility of the operator
that national regulations during oper-
ation and regarding a repeated safety
inspection of electrical equipment are
complied with. For Germany these
are the regulation 3 by DGUV (Ger-
man Statutory Accident Insurance) in
relation with VDE 0701-0702 (Associ-
ation for Electrical, Electronic and In-
formation Technology).
EN
• Information on REACH and SVHC
is available on our website
www.renfert.com, in the Support area.

3.3 Liability Exclusion

Renfert GmbH shall be absolved from all
claims for damages or warranty if:
• The product is employed for any pur-
poses other than those cited in the
operating instructions;
• The product is altered in any way oth-
er than those alterations described in
the operating instructions;
• The product is repaired by other than
an authorized facility or if any but
Renfert OEM parts are employed;
• The product continues to be em-
ployed, despite obvious safety faults;
• The product is subjected to mechani-
cal jarring or is dropped.

4. Operating Elements

(Figure 1a + 1b)
A) On / Off switch
B) Wax pot selection button
C) LED indicator for the selected wax pot
>> Operation indicator = green
>> Warm-up phase = red
D) Set-point temperature increase
E) Set-point temperature decrease
F) Setpoint / actual temperature display
G) Wax pot
H) Lid
I) Power cord
5. Commissioning /
Operation

5.1 Switching the Unit On

1. Connect the Vario E to the mains power
outlet (Figure 2).
2. Open lid (H). The lid can be locked in
place at a 120° angle (Figure 3).
3. Add the waxes to be heated to the pots.
- 2 -