2�4 Hazards And Warnings; 2�5 Authorised Persons; 2�6 Liability Exclusion - Renfert Basic quattro Mode D'emploi D'origine

Masquer les pouces Voir aussi pour Basic quattro:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
2.4
Hazards and warnings
EN
► If the unit is not used according to the instructions for use, then protection can no longer be guar-
anteed.
► The unit may only be used together with a mains cable with a country specific plug system. If a
plug exchange is necessary, this may only be undertaken by a skilled electrician.
► The mains plug must be easy to access.
► Check connection cables (e.g. power cable), tubes and housing (e.g. operating key pad) regularly
for damage (e.g. kinks, cracks, porosity) or aging. Appliances with damaged connection cables,
tubes or housing parts or other defects must no longer be operated! Remove the power cable and
secure against being switched on again!
► Risk of Injury!
If unauthorised attachments are used, there is a danger of injury. Only original Renfert fittings and
accessories may be used.
► Please observe the accident prevention regulations provided by the „employer's liability insur-
ance association"!
► Always disconnect the unit from the compressed air and power sources prior to beginning any
maintenance work.
► When working on the tank (filling up, cleaning, maintenance) wear protective glasses for protect-
ing your eyes.
► Any residue of abrasive material on the gasket may lead to leakage and early wear of the gasket.
After filling up clean the thread and the gasket and close the lid properly.
► DO NOT use solvent-containing cleaning agents or disinfectants.
► Solvents and tensides can create micro-cracking in the plastic (danger of explosion!). Clean the
tank and the lid only with a dry cloth. Do not write or stick something on the tanks.
► Do not unscrew the tank lid as long as the pressure had not been released
► Check the tanks and the lids regularly on damages and replace them in case of doubt.
► Check the tank cover for correct seating prior to beginning operation. Covers that are not secure-
ly closed can suddenly be blown off as the tank pressure increases. The resulting flying parts and
abrasive represent a serious hazard.
► Never operate the blasting units without suitable dust extraction and appropriate protective gear,
as this could result in health hazards. The type of dust extraction should be selected on the basis
of the dust being generated. Follow here absolutely EN 60335-2-69 appendix AA or ask the appro-
priate authorities.
► Improper use can result in the risk of eye or skin injuries.
► Never direct the blasting material towards eyes or unprotected areas of skin!
► Never work with the view screen open!
► Caution: Failure to wear proper eye protection can result in eye injury due to particles suspended
in the air. Always wear proper eye protection to protect your vision!
► Do not employ the foot switch when only the compressed air supply hose is connected. The loose
hose could wrap around itself and cause serious injury.
► It is the responsibility of the operator that national regulations during operation and regarding a
repeated safety inspection of electrical equipment are complied with. For Germany these are the
regulation 3 by DGUV (German Statutory Accident Insurance) in relation with VDE 0701-0702
(Association for Electrical & Electronic Technology).
► Information on REACH and SVHC is available on our website www.renfert.com, in the Support
area.
2.5
Authorised persons
This product may only be used by persons over the age of 14� Operation and service may only be carried
out by trained personnel� Repairs which are not described in these instructions may only be carried out by
skilled electricians and the specialist dealers�
2.6
Liability Exclusion
Renfert GmbH shall be absolved from all claims for damages or warranty if:
► The product is employed for any purposes other than those cited in the operating instructions.
► The product is altered in any way other than those alterations described in the operating instruc-
tions.
► The product is repaired by other than an authorized facility or if any but Renfert OEM parts are
employed.
► The product continues to be employed, despite obvious safety faults.
► In the case of mechanical impact or if the unit is dropped.
► Accessories or consumer products used, which are not supplied or authorised by Renfert GmbH.
- 4 -

Publicité

Table des Matières
loading

Table des Matières