Application Area; Environmental Conditions; Safety Information; Liability Exclusion - Renfert Twister Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 19
ENGLISH
1. Introduction
We are pleased with your decision to
purchase a Twister vacuum mixer.
Please observe the following information
in order to ensure long and trouble-free
service.

2. Application Area

The Twister vacuum mixer is designed
for homogeneous, bubble-free mixing of
only dental casting and modelling mate-
rials such as plasters, investments, and
silicons.

2.1 Environmental Conditions

(according to DIN EN 61010)
The device may only be operated:
• In interior areas;
• Up to an altitude of 2,000 m above sea
level;
• At an ambient temperature range bet-
ween 5-40°C [41-104°F];
• At a maximum relative humidity of 80%
at 31°C [87.8°F], dropping in a linear
manner to 50% relative humidity at 40°C
[104°F];
• At mains power fluctuations where the
voltage fluctuations do not exceed 10%
of the nominal value;
• At contamination level 1.

3. Safety Information

Before starting the device,
compare the information on the
nameplate with the specifica-
tions of your local power supply.
Immediately replace damaged
power cords.
Only authorized service person-
nel may performs repairs to the
open device.
Twister
No. 1820-0000 / 1820-1000
- 13 -
Disconnect the device from the
power supply before beginning
any maintenance work.
Manipulating the automatic bowl
coupler and the intake opening
can result in damage to the de-
vice and personal injury.
The device may only be used
to mix plaster, investment, and
silicon.
Never connect the paddle wi-
thout the mixing bowl.

3.1 Liability Exclusion

Renfert GmbH shall be absolved from
all claims for damages or warranty if:
• The product is employed for any pur-
poses other than those cited in the
operating instructions;
• The product is altered in any way
other than those alterations descri-
bed in the operating instructions;
• The product is repaired by other than
an authorized facility or if any but
Renfert OEM parts are employed;
• The product continues to be emplo-
yed, despite obvious safety faults;
• The product is exposed to mechani-
cal shocks or is being dropped.
4. Installation
4.1 Wall Mounting
(with set enclosed)
Please have the following items on hand:
pencil, drill template, Phillips head scre-
wdriver, drill + drill bit 8 mm [0.3152 inch]
- appropriate for the wall material.
Make sure the wall on which you intend
to mount the device is capable of bea-
ring its weight.
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1820-0000R1820-1000

Table des Matières