Renfert Vario E Mode D'emploi page 13

Caution:
Do not overfill the pot. The
scoring all around the upper pot
rim marks the limit for the max.
filling height.
4. Switch the Vario E on at switch (A)
(Figure 4).
5. The most recently selected unit of tem-
perature (°C or °F) appears for approx.
2 sec. on the display (F).
C = degrees Celsius (Figure 7a) or
F= degrees Fahrenheit (Figure 7b)
6. The display (F) then shows the most re-
cently entered setpoint temperature for
the selected pot for approx. 2 sec. The
selected pot is indicated by the LED (C).
7. Finally, the display (F) shows the current
actual temperature in the most recently
selected pot. The selected pot is indicat-
ed by the LED (C).
5.2 Specifying the Desired Tem-
perature Unit (°C or °F)
Note:
Please note that 230 V units
have been preset to °C at the
factor, while 120 V units are
preset to °F.
1. If your Vario E is switched on, please
turn it off at switch (A).
2. Press and hold key (B) approx. 2 sec.
(Figure 5) while simultaneously turning
the Vario E on at switch (A) (Figure 4).
3. The units of temperature, °C and °F are
alternately shown for approx. 2 sec. on
the display (F) (Figure 7a + 7b). Re-
lease key (B) when the desired unit is
displayed.
4. The most recently displayed unit of
temperature is saved.
5.3 Set-point Temperature Adjust-
ment
1. Use switch (B) to select the desired wax
pot (Figure 5).
2. The LED (C) associated with the select-
ed pot goes on (red or green) (Figure 6).
• Right-hand wax pot = Right-hand LED;
• Centre wax pot = Centre LED;
• Left-hand wax pot = Left-hand LED;
3. Display (F) first shows the setpoint tem-
perature for approx. 2 sec., followed by
the actual temperature.
4. Pressing either key (D +) or (E -) the
display (F) switches on to the currently
specified setpoint temperature
(Figure 9 + 10).
5. Pressing keys (D +) or (E -) resets
the desired setpoint temperature
(adjustment range: 45 - 110 °C or
113 - 230 °F).
= Increase temperature
= Decrease temperature
By pressing the Minus-Key once again
at 45 °C (113 °F), the corresponding pot
will be switched off (the display shows
OFF). By pressing the plus-key, the pot
will be switched on again beginning at
45 °C (113 °F). If an attempt is made to
set a temperature higher than 110 °C
(230 °F), the value of 110 (230) will flash
on the display (F).
6. After approx. 2 sec., the display (F)
automatically switches to the actual
temperature in the selected pot.
When the pre-set temperature on the
selected pot is reached, the indication
on the corresponding LED will turn from
red to green (Figura 8). The indication
on the LED (C) will always shortly turn
on red when re-adjusting temperature.
- 3 - EN