Installing The Controller - Dometic CAM 360 AHD Instructions De Montage

CAM360AHD
If you would like to attach the camera with threaded bolts fitted through
the construction
A
NOTICE! Damage hazard
Ensure that nuts cannot be pulled through the body shell when they are
tightened. Use larger washers or metal plates if necessary.
➤ Drill a hole of Ø 6 mm for the cable entry (fig. f, page 9).
➤ Guide the camera cable into the vehicle interior (fig. g, page 9).
➤ Mark the holes for the mounting screws (fig. h 1, page 9).
➤ Remove the camera (fig. h 2, page 9).
➤ Drill two holes of Ø 3.5 mm for the camera bracket.
➤ Guide the camera cable into the vehicle interior.
➤ Screw on the camera with M3 x 20 mm threaded screws.
Depending on the thickness of the construction, you may require longer
threaded screws.
7.5

Installing the controller

A
NOTICE! Damage hazard
The control unit must not be exposed to direct sunlight.
I
NOTE
If you are using a flash drive to store the video data, route the USB cable
(fig. e 4, page 8) to an easily accessible location.
The control unit is supplied ready for installation.
➤ Install the control unit in a location protected from water near the monitor,
preferably under the dashboard or under the driver's seat.
➤ Secure the control unit in place using the included bolts.
7.6 Installing the infrared receiver
➤ For the infrared receiver, select an installation location that is in line of sight of the
remote control.
➤ Secure the infrared receiver with the included double-sided tape.
EN
Installing the video system
25