Checking The Function And Setting The Camera - Dometic WAECO PerfectView CAM33C Notice De Montage Et D'utilisation

_CAM33.book Seite 45 Freitag, 20. Mai 2011 11:40 11
PerfectView CAM33
7.5 Connecting the RV-AMP/4 switchbox
(only CAM33C2, CAM33C3) (fig. q, page 11)
I
NOTE
If you would like to use both camera modules when driving for-
wards, you will need to fit the flip switch supplied (see the installa-
tion and operating manual for RV-AMP/4).
The switchbox is supplied ready for installation.
➤ Mount the switchbox as described in the corresponding installation and
operating manual.
I
NOTE
Output "2" on the switchbox is an auxiliary output, e.g. for connect-
ing an external monitor.
➤ Connect the switchbox electrically as described in the corresponding in-
stallation and operating manual.
7.6

Checking the function and setting the camera

➤ Check the function of the camera after you have connected it to a monitor.
➤ Align the camera using the image on the monitor to help you:
The monitor image should show the rear or the bumper of the vehicle at
the bottom edge of the screen. The middle of the bumper should be in
the middle of the screen (fig. o, page 10).
➤ Tighten the six fastening screws of the camera bracket.
Settings for contrast and brightness can be made on the monitor.
EN
Fitting the camera
45