Dometic WAECO PerfectView CAM33C Notice De Montage Et D'utilisation page 33

_CAM33.book Seite 33 Freitag, 20. Mai 2011 11:40 11
PerfectView CAM33
Observe the following installation instructions:
 Secure the parts of the camera installed in the vehicle in such a way that
they cannot become loose under any circumstances (sudden braking, ac-
cidents) or cause injuries to the occupants of the vehicle.
 Secure any parts of the system covered by the bodywork in such a man-
ner that they cannot be come loose or damage other parts and cables or
impair vehicle functions (steering, pedals, etc).
 To prevent damage when drilling, make sure there is sufficient space on
the other side for the drill head to come out (fig. 2, page 4).
 Deburr all drill holes and treat them with a rust-protection agent.
 Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.) may only
be performed by qualified specialists.
Observe the following instructions when working with electrical parts:
 When testing the voltage in electrical cables, only use a diode test lamp
(fig. 1 8, page 3) or a voltmeter (fig. 1 9, page 3).
Test lamps with an illuminant (fig. 1 12, page 3) consume voltages that
are too high and can damage the vehicle's electronic system.
 When making electrical connections, ensure that:
– They are not kinked or twisted
– They do not rub on edges
– They are not laid through sharp-edged ducts without protection
(fig. 3, page 4).
 Insulate all connections.
 Protect the cables from mechanical wear (for example rubbing against ex-
isting cables) using cable binders or insulating tape.
The camera is watertight. However, the seals on the camera cannot with-
stand a high-pressure cleaner (fig. 4, page 4). Therefore, you should ob-
serve the following instructions when handling the camera:
 Do not open the camera, as this impairs the watertightness and the func-
tion of the camera (fig. 5, page 4).
 Do not pull on the cables, as this impairs the watertightness and the
function of the camera (fig. 6, page 4).
 The camera is not suitable for use under water (fig. 7, page 4)!
EN
Safety and installation instructions
33