Dometic WAECO PerfectView CAM33C Notice De Montage Et D'utilisation page 43

_CAM33.book Seite 43 Freitag, 20. Mai 2011 11:40 11
PerfectView CAM33
A
NOTICE! Risk of damage!
Ensure that there is sufficient space on the other side for the drill
head to come out
➤ Drill a hole of Ø 16 mm near the camera.
➤ Deburr all drill holes that have been made in the sheet metal and apply
rust-protection.
➤ Place cable sleeves in all sharp-edged ducts.
Attaching the camera and camera guard
A
NOTICE!
Never mount the camera without the additional camera guard. To
mount the camera guard, only use the M3 x 8 mm screws provid-
ed. Longer screws will damage the camera.
➤ Push the camera guard (fig. 8 4, page 5) over the camera in such a way
that:
– The fixing hole of the camera guard (fig. l, page 9) is over the 3-mm
thread of the camera.
– The two other fixing holes (fig. m, page 9) are over the 4-mm threads
of the camera.
➤ Secure the camera guard with the two M3 x 6 mm screws in the hole
(fig. l, page 9).
➤ Push the camera into the bracket (fig. m, page 9).
A
NOTICE!
Only use the screws supplied to mount the camera in the camera
holder. Longer screws will damage the camera.
➤ Secure the camera loosely with the four M4 x 10 mm screws in the two
other fixing holes (fig. m, page 9).
The camera is now centred.
➤ Align the camera so that the lens is at an angle of approx. 20° to the ver-
tical axis of the vehicle (fig. n, page 9).
EN
Fitting the camera
43